HPT-200 Benchtop Plasma Treater

The HPT-200 is a microprocessor controlled benchtop plasma treatment system which is ideally suited to surface activation, cleaning and modification of a wide range of materials including polymers, metals, glass and ceramics. Available in single or dual gas inlet versions and with on-board gas mixing manifold, the HPT-200 is able to handle a wide range of gases for optimised treatments, including air, oxygen, hydrogen, argon, nitrogen and many others. An optional vapour delivery inlet extends the use to liquid precursors and a
corrosion resistant version expands the choice even further to address specific material treatments including;

  • Plasma cleaning.
  • Plasma surface activation to improve adhesion
  • Functional plasma coatings
  • Plasma etching
  • PDMS & microfluidic devices
  • PEEK & other engineering polymers
  • PTFE
  • Metals
  • Ceramics
  • Glass & optical devices

– compact benchtop unit
– user friendly TFT interface
– recipe store
– fast treatment time
– precise & repeatable
– no hazardous emissions

The HPT-200 features a 150mm diameter plasma process chamber in stainless steel with vacuum compatible materials throughout. Our proprietary, high stability HPS plasma generator is continuously variable over the entire 0-200W power range rather than being limited to discreet levels, delivering much finer control when processing delicate materials.

The 5.7 inch colour touchscreen provides a rich, user-friendly interface. Variables such as gas flow rate, pressure, power level and plasma processing time can be freely set and then stored to produce a fully interlocked process cycle from a single keypress. A handy status display and end of process audible alarm informs the user of every
step in the process.

With precision digital mass flow controllers and integrated pressure gauge, the HPT-200 delivers unmatched reliability and repeatability by removing common errors in gas flow and gas type settings which will be familiar to users of equivalent equipment that utilise manual needle valves.

The base model HPT-200 has a single gas inlet and optional second gas or vapour delivery inlet. The unit is prepared so that either option can be added at a later time if required, ensuring that future requirements can
be accommodated without
expensive reconfiguration.


Dimensions: W 520mm x H 286mm x L 550mm (+50mm on rear for cables)
Weight: 23kg

Material: Stainless Steel and borosilicate glass, quartz glass
Form: Cylindrical
Dimensions: 150mm dia. x 280mm L

Material: Aluminium and stainless steel, borosilicate glass, quartz glass

Form: Flat tray, perforated tray, others to suit application

Dimensions: 135mm W x 255mm L


Power: 0-200W, continuously variable output

Frequency: kHz


Interface: 5.7” Colour TFT
Gas channels: x1 MFC x2 MFC or x1 MFC and x1 vapour inlet
Vent inlet: x1 soft ventilation option
Connections: 6mm compression
Process timer: 1sec – 99.59min
Pressure gauge: Pirani sensor
Vacuum pump: 2-stage rotary* others to suit application
*Suitable for use with air, oxygen and other non-corrosive gases

Electrical: 110-250 AC, 50-60Hz, 450 VA (including pump), fused 6.3 A T

Power cord: Suited to region

Compliance: CE – ROHS – WEEE









Warranty: 02 (Two) years from the date of Successfully completion of Supply.  

Leave a Reply

Your email address will not be published. Required fields are marked *